Loctite™ Fixmaster® Poxy Pak™, Fast Cure Epoxy
EMS #12646-09
This fast cure, general purpose epoxy bonds virtually any material. It will also fill or seal cracks and rebuild worn surfaces. Comes in a 1 oz. syringe with a built-in plunger for easy dispensing without equipment. Working time is approximately 4 minutes. Includes nozzle and mixing stick.
This unique adhesive may be made electrically conductive with the addition of any conductive powder (Silver, Carbon, etc.)
Part A
Warning: Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation.
Prevention: Avoid breathing vapors, mist, or spray. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace. Wear eye and face protection. Wear protective gloves.
Response: IF ON SKIN: Wash with plenty of soap and water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to remove. Continue rinsing. If skin irritation or rash occurs: Get medical attention. If eye irritation persists: Get medical attention. Take off contaminated clothing.
Disposal: Dispose of contents and/or container according to Federal, State/Provinical and local governmental regulations.
Part B
Danger: Causes severe skin burns and eye damage. May cause an allergic skin reaction. Toxic if inhaled.
Prevention: Do not breathe vapors, mist, or spray. Wash thoroughly after handling. Use only outdoors or in a well ventilated area. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves, eye protection, and face protection.
Response:
- IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
- If ON SKIN OR HAIR: Immediately take off all contaminated clothing.
- IF INHALED: Remove person to fresh air and keep comfortable for breathing.
- IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to remove. Continue rinsing. Immediately call a poison control center or physician.
- If skin irritation or rash occurs: Get medical attention.
- Wash contaminated clothing before reuse.
Storage: Store in a well-ventilated place. Keep container tightly closed. Store locked up.
Disposal: Dispose of contents and/or container according to Federal, State/Provincial and local governmental regulations. KEEP OUT OF THE REACH OF CHILDREN. For industrial use only.
Directions
- Clean Surfaces
- For best adhesion, roughen surfaces.
- Snip syringe tips.
- Dispense epoxy and mix thoroughly.
- Apply epoxy to one surface, assemble.
- Remove excess adhesive at once.
- Allow parts to sit for 5-8 minutes before moving.
- Detach cap from center of syringe handle and place on syringe tip for storage.
Product Information
Loctite™ Fixmaster® Poxy Pak™, Fast Cure Epoxy