Questions? 800-523-5874 | [email protected]
- Prepmaster™ Specimen Preparation Robot
- TEM Grids
- TEM Window Grids
- Omniprobe Nanomanipulation Systems
- K-kit Wet "Liquid" TEM Kit
- Specimen Mounts
- SEM Specimen Holders
- Index and Finder SEM Grids
- SEM for Forensics
- SEM Sample Preparation Station Materials
- Cryogenic Personal Protection Equipment
- Cryo Dewars & Flasks
- Cryogenic Grids & Accessories
- Cryogenic Vials & Racks
- Cooling Chambers & Ice Baths
- Prepmaster™ Specimen Preparation Robot
- Laboratory Microwave Ovens
- LYNX II Automated Tissue Processor
- EMS Poly III
- Microtomes
- Tissue Slicers
- Rapid Immersion Freezer
- Heaters & Chillers
- SEM Cooling Stage
- Glow Discharge Systems
- Sputter Coaters & Carbon Coaters
- Stages
- Freeze Dryers
- Critical Point Dryers
- Cryo-SEM Preparation System
- Specimen Transfer Systems
- Decontaminators
- Desiccators
- Centrifuges
- Dry Baths
- Stirrers, Hot Plates
- Vortexers & Magnetic Mixers
- Rotators & Rockers
- Ovens & Incubators
- Vibration Isolation
- Air Sampling
- Vacuum Pumps
EMS Technical Data Sheets
Diamond Knife Wash Instructions
EMS Catalog #70605
- Put the knife wash on a Magnetic Stirrer. (make sure there is NO heat)
- Fit the Diamond Knife into the holder and tighten the screw making sure that the screw meets the rear of the boat.
- Fill the wash to the indicated line with distilled or deionized water (you may add two drops of very mild liquid detergent).
- Put the lid on the container (be careful when doing).
- Turn the magnetic stirrer on at a low speed for 5 minutes.
- Remove lid and take knife out.
- If desired and/or you used detergent, rinse the knife with distilled water.
- Either let the knife dry naturally or if you prefer you can dry it with a foam rod (polystyrene) dipped in absolute ethanol as usual.
Online Ordering
Diamond Knife Wash is available online from the EMS Catalog. For ordering or product information, click here.