Questions? 800-523-5874 | [email protected]
- TEM Grids
- Prepmaster™ Specimen Preparation Robot
- TEM Window Grids
- Omniprobe Nanomanipulation Systems
- K-kit Wet "Liquid" TEM Kit
- Specimen Mounts
- SEM Specimen Holders
- Index and Finder SEM Grids
- SEM for Forensics
- SEM Sample Preparation Station Materials
- Cryogenic Personal Protection Equipment
- Cryo Dewars & Flasks
- Cryogenic Grids & Accessories
- Cryogenic Vials & Racks
- Cooling Chambers & Ice Baths
- Prepmaster™ Specimen Preparation Robot
- Laboratory Microwave Ovens
- LYNX II Automated Tissue Processor
- EMS Poly III
- Microtomes
- Tissue Slicers
- Rapid Immersion Freezer
- Heaters & Chillers
- SEM Cooling Stage
- Glow Discharge Systems
- Sputter Coaters & Carbon Coaters
- Stages
- Freeze Dryers
- Critical Point Dryers
- Cryo-SEM Preparation System
- Specimen Transfer Systems
- Decontaminators
- Desiccators
- Centrifuges
- Dry Baths
- Stirrers, Hot Plates
- Vortexers & Magnetic Mixers
- Rotators & Rockers
- Ovens & Incubators
- Vibration Isolation
- Air Sampling
- Vacuum Pumps
EMS Technical Data Sheets
Vortex Genie Shock Absorbing Feet
EMS Catalog #71842-51
Introduction
These shock absorbing feet with screws are for the Analog and Digital Vortex Genie® 2 & Vortex Genie® 2T (Catalog #71838 Series).
Installation
- Unplug the mixer from any electrical outlet.
- Remove any one of the bottom corner screws, leaving the remaining three in place.
Note: Do not remove all four screws, to avoid exposing internal components. - Replace with the new screw and foot. Do not over tighten.
- Repeat steps 2 and 3 for remaining three screws and feet.
- Your Vortex-Genie® 2 mixer may have the older style rubber strips for feet – one strip in the front and one in the back – if it does, these strips should be removed after the new feet are installed.