Questions? 800-523-5874 | [email protected]
- TEM Grids
- Prepmaster™ Specimen Preparation Robot
- TEM Window Grids
- Omniprobe Nanomanipulation Systems
- K-kit Wet "Liquid" TEM Kit
- Specimen Mounts
- SEM Specimen Holders
- Index and Finder SEM Grids
- SEM for Forensics
- SEM Sample Preparation Station Materials
- Cryogenic Personal Protection Equipment
- Cryo Dewars & Flasks
- Cryogenic Grids & Accessories
- Cryogenic Vials & Racks
- Cooling Chambers & Ice Baths
- Prepmaster™ Specimen Preparation Robot
- Laboratory Microwave Ovens
- LYNX II Automated Tissue Processor
- EMS Poly III
- Microtomes
- Tissue Slicers
- Rapid Immersion Freezer
- Heaters & Chillers
- SEM Cooling Stage
- Glow Discharge Systems
- Sputter Coaters & Carbon Coaters
- Stages
- Freeze Dryers
- Critical Point Dryers
- Cryo-SEM Preparation System
- Specimen Transfer Systems
- Decontaminators
- Desiccators
- Centrifuges
- Dry Baths
- Stirrers, Hot Plates
- Vortexers & Magnetic Mixers
- Rotators & Rockers
- Ovens & Incubators
- Vibration Isolation
- Air Sampling
- Vacuum Pumps
EMS Technical Data Sheets
EMS Vornado™ Mini Vortexer
EMS #87001-Series
Introduction
The EMS Vornado Mini Vortexer is a compact, powerful, vortex mixer designed for vortexing micro tubes of all sizes. Dynamic balance technology provides smooth speed control and quiet operation with minimal vibration.
Set Up
Place the vortex mixer on a clean, flat, stable surface, and press down slightly to allow the feet to adhere. Plug the vortex mixer into a properly grounded outlet.
Operation
Take the tube/vessel to be mixed and pressed downward against the head to activate the vortex mixing action (called "touch" mix). When finished mixing, lift the tube upward.
Care and Maintenance
No routine maintenance is required other than to keep the unit clean. Cleaning can be done with a damp cloth. Avoid the use of solvents as they may attack the rubber cap head or the ABS plastic housing. Do not immerse the mini vortexer in liquid or subject it to temperatures outside of the recommended operating range.
In the event that service or technical support is required, please contact Electron Microscopy Sciences at 1-800-523-5874.
Specifications
| Speed | Fixed: 2800 rpm |
| Operation | "Touch" mix |
| Head | Rubber cap standard for single tube mixing |
| Dimensions (w x d x h) | 9.4 x 9.9 x 6.6 cm (3.7 x 3.9 x 2.6") |
| Weight | 0.4 kg (1 lb) |
| Electrical | Universal, 100-240V, 50-60 Hz |
| Operating environment | 4° to 65°C |
| Warranty | 2 Years |
Troubleshooting
| Unit does not turn on | Ensure that the vortexer is firmly plugged into the outlet; check the voltage of the outlet. |
| Motor starts slowly | Ensure proper operating temperature. |