Questions? 800-523-5874 | [email protected]
- TEM Grids
- Prepmaster™ Specimen Preparation Robot
- TEM Window Grids
- Omniprobe Nanomanipulation Systems
- K-kit Wet "Liquid" TEM Kit
- Specimen Mounts
- SEM Specimen Holders
- Index and Finder SEM Grids
- SEM for Forensics
- SEM Sample Preparation Station Materials
- Cryogenic Personal Protection Equipment
- Cryo Dewars & Flasks
- Cryo-EM Grids & Grid Storage
- Cryogenic Vials & Racks
- Cryo-EM Vitrification Supplies
- Prepmaster™ Specimen Preparation Robot
- Laboratory Microwave Ovens
- LYNX II Automated Tissue Processor
- EMS Poly III
- Microtomes
- Tissue Slicers
- Heaters & Chillers
- SEM Cooling Stage
- Glow Discharge Systems
- Sputter Coaters & Carbon Coaters
- Stages
- Freeze Dryers
- Critical Point Dryers
- Cryo-SEM Preparation System
- Specimen Transfer Systems
- Decontaminators
- Desiccators
- Centrifuges
- Dry Baths
- Stirrers, Hot Plates
- Vortexers & Magnetic Mixers
- Rotators & Rockers
- Ovens & Incubators
- Vibration Isolation
- Air Sampling
- Vacuum Pumps
EMS Technical Data Sheets
Unimount Epoxy Kit
EMS Catalog #1234
Unimount Mixing Instructions
- Weigh out the correct amount of hardener in a mixing cup.
- Weigh out the corresponding amount of resin into the same mixing cup.
- Stir thoroughly for net less than 5 minutes until the mixture is homogeneous, without introducing air bubbles.
- Place the specimen in the middle of the mounting cup and carefully pour in the mixed epoxy.
- Ensure that no air remains trapped within gaps or cavities in the specimen by moving the specimen or by tapping the mounting cup on the table.
Unimount cures at 75°C/167°F, the curing time is 1½ hours at 75°C/167°F. To obtain these temperatures, either a laboratory oven/heating cabinet or Drybox can be used. When using a oven/cabinet we recommend using one with good ventilation to ensure that the heat created by the exothermic reaction during curing is removed.
| Mixing Ratio: | By Weight: Resin/Hardener: 25/7 By Volume: Resin/Hardener: 31/10 |
| Potlife: (30 g mixture at 21°C/70°F): | 4 Hours |
| Hardening Time (30 g mixture at 21°C/70°F): | 1½ hours in oven at 75°C/167°F |
| Peak Temperature(30 mm dia embedding w/o specimen at 75°C/167°) | 170°C/338°F |
| Hardness | 85 Shore D |
| Color | Clear, Transparent |
| Density (g/ml) | Resin: 1.13 / Hardener: 0.96 |
| Soluble in | Resin & Hardener: Alcohol, acetone |
| Chemical resistance after curing | Most common acids & bases |