Our accessories and options can be used with any of our range of tables and platforms over 60 x 60 cm, to improve the environment for your instruments, as well as make your work easier.
Frames bolt directly to the platforms and feature a hard gray epoxy powder finish. They are supplied with four leveling feet, giving 3 cm of adjustment to ensure the frame's stability on the most uneven floors. Frame height 71 cm, going to a working height of 78 cm.
Made from 2 cm laminated board and is suitable for supporting equipment such as computers.
The platform guard is a sturdy rail (with side rail option) that fully surrounds the platform and protects it against accidental knocks, which would otherwise disturb instruments on the platform.
A 30 cm wide shelf, which sits on the guard rail over the platform and is quick and easy to remove and replace.
These castors incorporate a foot, which can be raised and lowered using a thumbwheel, allowing the workstation to be wheeled around and then securely mounted to the floor in a new location.
Supports monitors weighing up to 30 kg. It features 360 degree rotation of the arm as well as height adjustment. It mounts to the platform guard.
Flat Screen Monitor Arm
The LCD monitor post bolts to the back guard at position of either the right or left support bar. It has an adjustable multi directional arm that allows the user to place the screen at the height and position most comfortable for use. It will support most standard monitor brackets. They also bolt directly to the AMT table tops (version shown).
Attaches to the base of the platform and is pulled out as required. It measures 50 x 35 cm (W x D) and will accommodate most keyboards.
These compact and oil free air compressors are virtually silent (30dB/A) versions and suitable for running several platforms.
Air Preparation Unit (not pictured)
An air preparation unit should be used if compressed air is used which may be damp or contain small particles. The unit will ensure the air supply is properly cleaned and dry before entering the platforms.
With noise levels of less than 47dB and almost no vibration, this is the best compressor for use with vibration isolation tables. The rings ensure the air is clean and pure and each compressor is fitted with a 10 bar regulator and 5 micron filter as standard. The air output is 6 mm push fitting standard or 1/8 BSP if preferred. Models include: USA version 115Vac, European version 220Vac, and UK version 240Vac.